網頁文章
使用Arduino可將程式嵌入進在路板 將電路板插入USB從裝置管理員可看到Arduino Uno 為COM3的插槽,所以要在Arduino上選則COM3的插槽,再按下箭頭可上傳程式進電路板。 依程式open-blink範例:可調整pin 13腳位通電斷電以達到LED開關的時間控制 void setup() { // initialize digital pin 13 as an output. pinMode(13, OUTPUT); }
// the loop function runs over and over again forever void loop() { digitalWrite(13, HIGH); // turn the LED on (HIGH is the voltage level) delay(50); // wait for a second digitalWrite(13, LOW); // turn the LED off by making the voltage LOW delay(3000); // wait for a second } |